IDEAS IN FORM AND COLOUR.

K&T Kunststoff-Technologie GmbH

From the idea to the prototype to the series …
… we are the right point of contact for you.

Accessories

Our eleven in-mould machines have a locking pressure of 20 – 150 tons and a shot weight of 0.50 – 250 grams.

If desired, we can also take on the execution of construction group completions for you.

Are you interested in 2K in-mould products or products with a higher volume and shot weight? We can realise this together with our partners.

We are also happy to work with you in regards to commission processing. Interested? Please do not hesitate to contact us.

Plastic injection moulding from Einbeck/OT Strodthagen all over the world

It is good to know that we not only work with forwarding agencies within Europe, upon which we have been able to rely for years, but that we are also active worldwide and that our products can be delivered via reliable partners, either by air or sea, in an uncomplicated and timely manner.

Direction block – an example of innovation

The direction block is used to ensure accurate laying and aligning of

  • gas concrete stones
  • hollow block stones
  • calcareous sand stones
  • or similar stonework and plates

Due to the sharp front edge, even stones and plates with extremely tight gaps may be aligned, as it is the case with glue-based stone elements.

The rough bottom side of the direction block helps to prevent unintentional displacements in the stonework.

The plastic is characterised by a high stability of the blow direction. Alternatively, the direction block, which has been inserted into the stonework, may be edged off and knocked off by softly hitting onto one of its bearing surfaces.

The part of the direction block, which remains in the stonework, succinctly sits in the planning level of the stonework.

Model: direction block
Colour: white
Article number: 77020
Accounting unit: 200 pieces in a plastic bag

We are your competent contact
for development,
construction
and manufacturing.

Contact us.
Contact us